航空器材网|Airparts.cn


Email：	*	Password：	*

Home

Part Number

Description

2715 companies with 2851349 item

Products

Information

Name： Ruska Laboratory Air Data Test Set

Model： AeroCal 7750i

Supplier：GE

Contact Info

www.gesensing.com

Product Introduction：

The AeroCal 7750i is a laboratory ADTS for calibrating a wide variety of avionics instrumentation such as altimeters, airspeed indicators, rate of climb meters,Mach meters, air data computers and engine-based control systems that rely on accurate control and measurement of pressure. The AeroCal 7750i can be used to calibrate devices that are required to meet the Reduced Vertical Separation Minimal (RVSM) requirements, controlling altitude to within two feet(better than 0.003 in Hg) at sea level. Additionally, the AeroCal 7750i provides precision rate control for both altitude and airspeed.

Technical Parameter：

Automatic Go to Ground	Upon selecting the go to ground command, the 7750i safely controls the pressure to the current, local barometric pressure. The user can then disconnect the device under test (DUT) without exposing sensitive instruments to a potential pressure transient or shock.
Leak Test Mode	A separate mode is provided for performing leak checks prior to beginning an actual calibration.
Protecting the Device Under Test	In order to protect the DUT, the operator can program high and low limit settings for: Altitude Airspeed Rate of climb Mach Negative Qc ARINC 565 envelope
Automatic Volume Characterization	The 7750i automatically tunes the controller into external volumes ranging from 5 to 60 cubic inches (80 to 1000 cc). This allows a large degree of flexibility for the configuration of the test system and the type of aircraft and components to be tested. For component manufacturers, a large number of devices can be tested simultaneously on a single manifold.
Automatic Zeroing	As with any instrument, regular zeroing is suggested to achieve maximum performance. This task is now automated and can be performed at the push of a button, or over the PC interfaces. The 7750i incorporates the vacuum sensor onboard; no separate or external vacuum gauges or sensors are required. In addition, only one vacuum pump is required to operate and zero the 7750i ADTS. Zeroing is performed in 30 to 45 minutes using the specificed vacuum pump.
Avionics and Pressure Units	The Model 7750i displays the common avionics units including feet and meters for altitude, calibrated airspeed in knots, km/hr, and Mach with corresponding rate displays for each unit per minute. It can also display pressure units.